ENGLISH
CONTACT US
Commisioning: Close the the magnetic starter handle power transmission; 2 hand press the button points to open two or three times; 3, starting, idling for 1 to 2 weeks; 4, reproduced, crusher jointoperation; 5, check no exception, a start-up signal; 6, running machinery and motor vibration, normal voice and humidity, the various bearing temperature does not exceed 75 ° C, the motor temperature must not exceed specified by the manufacturer; 7 loader chainelastic must be the same in the case of a full load, the chain tension amount must not exceed the length of the two chain rings, no card chain, jump chain phenomenon; 8, the loader associated swivel fusible plug or easy fried chip damage notwood or other materials instead; 9, crusher the protected network security device should remain intact, in the course of their work should always check if any damage should immediately stop processing; 10, and the reproduced tail protection and other safety devices must ensure intact(2) to protect the cables, pipes, tubing, and hanging neatly; (3) Check the tunnel support; 11, shift loader (1) clean up the tail, the floating coal under the fuselage on both sides and across the bridge, floating Dagan;care, in the case of ensuring safe passage of loader; (4) trolley Belt Conveyor tailstock good contact, no deviation, good lap shift to prevent large pieces the gangue injured tape to ensurecoal smooth pass; (5) shift loader, nose, tail to keep the flat, straight, steady living, jack lever to recover.
